SERVICES


Electrical Panel Replacements and Upgrades
Tired breakers and undersized panels get replaced with modern service that carries today’s load safely. We size the upgrade to your real demand and leave clean, clearly labeled circuits behind.
- 100- to 200-amp service upgrades
- Panel and breaker replacements

Switch and Outlet Replacements and Upgrades
Worn switches and ungrounded two-prong outlets are swapped for grounded, code-current devices. We add GFCI and tamper-resistant protection where kitchens, baths, laundry rooms, and outdoor areas call for it.
- GFCI and AFCI outlet installation
- Switch, dimmer, and receptacle upgrades

Interior and Exterior Lighting
Recessed cans, fixtures, and outdoor fixtures are placed for even, efficient light. We handle new runs, LED retrofits, and controls so every room and entrance is lit the way you want.
- Recessed and fixture installation
- Landscape and security lighting

Pools, Spas, and Hot Tubs
Pools, spas, and hot tubs get dedicated, GFCI-protected circuits with proper bonding and clearly placed disconnects. We wire the equipment to code so the water stays safe to enjoy all season.
- Dedicated 240-volt spa circuits
- Bonding and disconnect installation

Generator Installations
Standby generators are set on a pad and tied to an automatic transfer switch that restores power on its own. We handle the electrical side from load calculation to final testing.
- Automatic transfer switch wiring
- Whole-home standby hookups

EV Charging Station Installation
Level 2 chargers get a dedicated 240-volt circuit sized for fast, safe home charging. We check your panel capacity and mount the unit where it best fits your daily routine.
- Dedicated 240-volt EV circuits
- Panel capacity checks

New Construction Electric and Remodeling
New builds and remodels get full rough-in wiring, load planning, and device placement. We coordinate around inspections so the electrical work is ready when the rest of the project is.
- Rough-in and finish wiring
- Load calculation and permits

Conduit EMT, PVC, and Rigid
Conductors get protected in the right raceway for the setting, whether thin-wall EMT indoors, PVC underground, or rigid where impact is a risk. We run clean, accessible lines built to last.
- EMT, PVC, and rigid runs
- Indoor, wet, and exposed routing

Electric Boat Hoists
Dock and lakefront boat hoists get weatherproof, GFCI-protected wiring built for the damp marine setting. We power the motor safely and place the disconnect exactly where code requires it.
- Weatherproof dock circuits
- GFCI-protected hoist motors

Smoke and CO Detectors
Interconnected smoke and carbon monoxide alarms get hardwired with battery backup and placed to code on every level. When one senses trouble, all of them sound, so the whole house hears the warning at once.
- Hardwired, interconnected alarms
- Smoke and CO coverage

Surge Protection
Whole-home surge protection mounts at the panel and clamps the spikes from storms, the grid, and everyday appliances before they reach your electronics. We layer it with point-of-use protection for the gear that matters most.
- Panel-mounted surge protector
- Layered point-of-use protection

Electric Heat
Baseboard, wall, furnace, and radiant heat get dedicated circuits sized to the load and thermostats wired to match. Each room stays warm through the coldest snaps without tripping a breaker or straining the wiring.
- Dedicated, correctly sized circuits
- Line-voltage thermostat wiring



